The Rotafix Timber - Resin Splice (TRS) system offers the very best method for the repair of in-situ timber joints, wall plates, lintels and structural timbers.

The Rotafix TRS is a new concept using our original resin technology to enable a section of tanalised, Stress Graded guaranteed timber (60 years) to be attached onto the end of our original joist or beam. Slots are cut, either from above or from the side, the accommodate rods and then the resin is simply injected from a standard cartridge.

The Rotafix Masonry Stitching system offers a simple yet reliable method of permanently repairing structural masonry and brickwork by 'over pinning' and permanently reinforcing vertical or stepped cracks in walls. This method restores the strength and stabilises the structure. Subsequent soft mortar repointing hides the reinforcing.

The repair method consists of grinding out every third or fourth mortar course to half the depth of the brick and fitting a special epoxy-glass rod with a solvent free epoxy resin applied by a cartridge gun.
It is essential that a Structural Engineer has been instructed to check that the reasons for the cracking have been established and the causes eliminated. Under no circumstances should cracks be stitched if the cause of the cracking is unknown.

ROTAFIX APPROVED INSTALLER